在线客服

网站公告: 保定市万嘉门窗制造有限公司坚持以诚信为本的理念,本着“同等价格比质量,同等质量比价格,同等价格、同等质量比服务。”的宗旨,为广大的新老客户打造出更完善的产品。

400-0312-611

保定市万嘉门窗制造有限公司

联系人:高先生 安女士

手 机:13803126757 13082332599

电 话:0312-5060303

邮 箱:13803126757@139. com

地址:河北省保定市北市区后辛庄工业区新民路39号

当前位置:门窗密封条安装注意事项
1、安装玻璃前要认真清除槽口内的杂物,如砂浆、砖屑、木块等,玻璃安放时应认真对中,保证两侧间隙均匀,并及时较正固定,防止碰撞移位,偏离槽口中心。 1, install the glass before notches to remove impurities, such as mortar, brick, wood, etc., glass should be carefully placed, ensure uniform clearance on both sides, and more are fixed in time, prevent collision shift, deviating from the groove center. 2、橡胶密封条不能拉得过紧,下料长度比装配长度长20-30mm。安装时应镶嵌到位,表面平直,与玻璃、玻璃槽口紧密接触,使玻璃周边受力均匀。在转角处橡胶条应作斜面断开,并在断开处注胶粘结牢固。 The rubber seal can not be pulled too tight, the lower material length is 20 to 30mm longer than the length of the assembly length. The installation should be set in place, the surface is straight, close contact with glass and glass slot, so that the surrounding force of the glass is uniform. The rubber strip at the corner should be inclined to be cut off, and the adhesive bond will be firm. 3、用密封胶填缝固定玻璃时,应先用橡胶条或橡胶块将玻璃挤住,留出注胶空隙,注胶深度应不小于5mm,在胶固化前,应保持玻璃不受振动。 3, when using a fixed glass sealant caulking, rubber or rubber should be used first glass choke, leave a note glue, rubber injection depth should not be less than 5 mm, before the adhesive curing, glass is not affected by the vibration shall be maintained.
关键字:门窗
网站建设:保定遨游公司 版权所有 © 保定市万嘉门窗制造有限公司  手机网站
联系人:安经理 服务热线:400-0312-611 电话:0312-5060303 手机:13082332599 网址:HTTP://www.bdwjmc.com
地址:河北省保定市北市区后辛庄工业区新民路39号 友链:保定保洁 护坡砖模具